Baby Panda Hueforge model, 4 Basic Colors

This is a cute baby panda Hueforge! It uses 4 simple colors, and below will be described on which layers to change colors. Dimensions are 200x200mm. You do not need the exact same colors, but please be as close as possible to the same colors. For example, different shades of blue can be used from the ideal blue, but do note your Hueforge may look slightly different. Anycubic Black PLA Anycubic Cyan PLA Anycubic Orange PLA Anycubic White PLA BEFORE GOING LOWER, PLEASE NOTE PRINT PROFILE WITH EXACT SETTINGS IS PROVIDED. RECCOMENDED TO USE THIS IF YOU OWN KOBRA S1 FOR OTHER MACHINES, FOLLOW BELOW INSTRUCTIONS ON HOW TO CHANGE THE CORRECT SETTINGS What settings to use? 99% infill First layer height 0.16mm Regular Layer height 0.08mm Where to set layer changes and swap filaments? Start the print with Black   At layer #8 (0.72mm) swap to Blue   At layer #11 (0.96mm) swap to Orange   At layer #13 (1.12mm) swap to White, and continue using for the rest of the print Please see Below screenshots for Additional clarification on how to change the correct settings To change filament at set layer heights, click on preview tab, let the model slice, and after slicing, locate the blue bar on the right side. Then, scroll down to the correct layer height, indicated by the above instructions on where to set layer changes and swap filament. After doing this, right click the + icon on the blue bar Doing so brings up something like this. Here, click change filament, and set the next filament needed. The instructions said to change to Blue at height 0.72mm, so click change filament, and set your blue filament. If you were successful, you will see a swap color icon. Now, continue doing this for the next 2 filaments. If you need to know where to swap, please refer to the swap instructions above. Image of a successful setup Your printer is now setup to swap to each material! From here, continue to print, and enjoy your baby panda Hueforge!