Thingiverse
Babylon 5 PPG Stand
by neophyl
119
Downloads
60
Likes
3
Makes
Designed to fit my build of Metaform3d's PPG model but should work for the standard model too.
I added a M3 hex cap head at the front to hold the heatsink in place on my PPG build and the stand has a recess for a 6mm x 1mm magnet, glued in, that grips that screw but it works without that.
v5b has had the poly count for the dome and rod increased as requested. Its about as good as I could get without re-doing the entire model again.
I added a M3 hex cap head at the front to hold the heatsink in place on my PPG build and the stand has a recess for a 6mm x 1mm magnet, glued in, that grips that screw but it works without that.
v5b has had the poly count for the dome and rod increased as requested. Its about as good as I could get without re-doing the entire model again.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
