MakerWorld
Bags
Model downloaden
Back pack strap handle
56
Downloads
32
Likes
23
Makes
This backpack strap handle can be used when putting on your backpack and tightening the straps. My issue was that when taking off my backpack, I often loosened the straps so much that there was only a small end of the strap left. And when putting on the backpack again (especially when it is heavy), it can be difficult getting a good grip on the straps to tighten the straps. With this handle you can easily get a good grip and tighten you back. Print the handle and insert the end of the strap. Insert the screw which will make sure the strap cannot slide out of the handle. When tightning the screws you might break of the screw heads (as seen on one of the pictures). This is not a big issue - and some might even prefer the handle without the screwhead! I have used it for a while, printed in pure PLA and have had not issues. The uploaded model is made in PLA-CF (Carbon Fiber) to make it stronger. Boost MeIf you like this model, then please consider boosting it :-)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!