Backflow Incense Burner (steps)

basic backflow incense holder, simple to print. make sure to slice with cura and enable the setting "make overhang printable" this was designed to take advantage of that feature, i haven't tested without

make sure to not place the incense directly on the plastic. instead get some wall filler and mould a hollow plug for the incense, you want the filler to be so thick it doesnt stick to the hand but when rolled around in hand the surface appears to get wetter. to make it adhere to the print, use a paint brush to brush some water on the plastic surface, for the hole i used a pencil. to dry i run 3 incense cones back to back, making sure to clear the hole between cones. due to water in the filler the hole will block slightly as it dries, once fully dried the hole will remain clear.


15/08/2021 added concept design this stemmed from (steps concept)