Slicer Discord
Backgammon Board Frame - Lux Kit – 3D-printbaar model van MakerWorld MakerWorld
Board Games

Backgammon Board Frame - Lux Kit

74 Downloads
35 Likes
20 Makes
Model downloaden
Updated note on 3/17/26:I got a report that sometimes the shells might warp a little bit and bend up on the corners, even though the magnets hold it closed. It just doesn't look great. I had this issue with certain filaments and certain build plates. The problem is on P-series Bambu printers, the size is nearly as wide as the build plate so an inconsistencies in heating or filament can cause bowing with stored stresses in the plastic. I experienced this on occasion (although I didn't have an issue with matte filament printed at the print settings included. The good news: here is a trick to fix it on one of my petg prints, I put a couple pennies in the middle and a little clamp on each side to hold the corners down. Then, put it on a piece of cardboard in your printer and warm it up a bit. Not super hot. I think I set it at 70 degrees and left it in there for 20-30 minutes. Take it out, let it fully cool off and then it should take all, or at least most of the warp out. I hope i
Categorie
Board Games
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, PETG
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

3 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie