Backgammon Board

# To Print

* 30x pieces, 15 of each if printing in different colors
* 2x large bowties
* 2x small bowties
* 2x board halves
* 2x board halves (mirrored)
* 24x triangles, 12 of each if printing in different colors

# To Buy

* [These magnets](https://www.amazon.com/gp/product/B077LCCGMM) (optional)
* [These dice](https://www.amazon.com/gp/product/B07CGYBNCF)

# Printing Instructions

I used magnetic filament for the triangles and painted them with spraypaint afterwards.

Use whatever colors you want and whatever plastic.

A little support material is needed for where the bowties fit in, but not a whole lot.

# Assembly Instructions

The magnets should fit in the pieces without any glue. Make sure they're all facing in the same direction so the pieces can stack.

The triangles required a little sanding to get to fit, but not much. No gluing necessary here either.

The bowties needed some expoxy, but that's optional I suppose. I left one half of the board u