Slicer Discord
Backup Camera Mount – 3D-Druckmodell von Thingiverse Thingiverse

Backup Camera Mount

14 Downloads
8 Likes
0 Makes
Zum Modell
This camera mount works with a S2000 equipped with an optional full display dimming rear view mirror from '20-'22 ZL1 LT4 Camaro. This mirror installation is intended to assist with parking and does not provide a good angle (camera is mounted too low) for full time use while driving.

This mount is designed to be used with two brass heat set inserts and four M3 screws.

The two mirror views shows the view with the digital tilt set to the highest and lowest settings.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen