Thingiverse
Badge Card Holder (Parameterized, Customizable)
door acmattson3
0
Downloads
2
Likes
0
Makes
An OpenSCAD parameterized card holder.
Print this with the card slot opening (not the front finger slot) facing up. Use a brim to minimize warping on the bottom and increase bed adhesion. Without a brim, it prints fine in my experience; just some mild warping.
Print this with the card slot opening (not the front finger slot) facing up. Use a brim to minimize warping on the bottom and increase bed adhesion. Without a brim, it prints fine in my experience; just some mild warping.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
