Badge Holder

Check out my other versions of this holder!Severance Keycard: Tesla: This is a simple badge holder. There are 3 small tabs on each side and a tab at the top to keep the badge held in place. It will fit a standard credit card sized card/badge/key. The fit is very tight and has a very satisfying slide and snap in. Includes 2 plates, one is the standard holder, the other has a small hole near the top to make removing the badge/card easier. Quick and easy print, the standard profile prints in about 25 minutes. I also included a 2nd profile for clear PETG. I have tuned my print and filament settings for a very clear print. Keep in mind it prints slower and takes significantly longer, but the results are beautiful. I printed the example ones with a smooth bed, you can use Textured PEI, though the texture will make it slightly less transparent. In the cover photo, you are seeing the test card through the back, showing the transparency.