Badge Holder - Version 2 (Vertical)

After several design drafts and testing. We have decided to replace our “Simple Badge Holder” that we had published on MakerWorld previously with our new version, the “Badge Holder - Version 2”. This is the Vertical Version. However, the Horizontal Version can be found here: Badge Holder - Version 2 (Horizontal) by Owl Amazing Crafts MakerWorld: Download Free 3D Models This version uses two parts. A front cover and a back cover. Once you place your badge inside, both the front and back covers slide and interlock together. Once you have your lanyard or badge reel clipped on, they will not separate, nor will the badge fall out. Also, this will print flat on the build plate compared the previous version. No more supports needed! This saves a lot of print time and filament. Now prints in approx. 35 minutes versus 1 hour. The second print profile for the rounded edges, will take about approx. 45 minutes due the smaller layer height. Can be printed with PLA or PETG. But if you leave in a hot