Thingiverse
badge pass
von maxball
10
Downloads
11
Likes
0
Makes
My badge for pass.
for card sizes 5.4 mm x 8.6 mm (+/- 0.5 mm)
After printing you may cut openings.
I am left this holes covered for better printing a face side
In this badge there are small latches on each side that do not allow it to open itself.
for card sizes 5.4 mm x 8.6 mm (+/- 0.5 mm)
After printing you may cut openings.
I am left this holes covered for better printing a face side
In this badge there are small latches on each side that do not allow it to open itself.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
