Thingiverse
Badger2040 Enclosure
9
Downloads
4
Likes
0
Makes
Update - Now contains a version with a small rear cutout to allow access to the rear buttons
Simple to print enclosure for the Badger2040, this enclosure allows power and the lanyard connection from the sides. If you also print the sliding door then it will also hold a small LiPo battery inside meaning no Velcro is needed to hold it in place.
This was created for my purposes, but I'm guessing other people may want this design too.
4xM2 screws and no nuts required.
Simple to print enclosure for the Badger2040, this enclosure allows power and the lanyard connection from the sides. If you also print the sliding door then it will also hold a small LiPo battery inside meaning no Velcro is needed to hold it in place.
This was created for my purposes, but I'm guessing other people may want this design too.
4xM2 screws and no nuts required.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
