Badgy Rev 1 Case

Quick case to hold my Badgy IoT Badge

https://www.tindie.com/products/squarofumi/badgy-iot-badge/


Update: This case fits a Rev. 1 Badgy Blue Board.

Rev 2B (and probably 2A) swap the position of the switch and USB and is slightly longer. I have updated the design and posted as: https://www.thingiverse.com/thing:3710620

Updated Version: 17Jan19
Removed the battery cutout - it was useless, a - too small (batteries tended to have diameter of 24.5+ mm, b - you couldn't get the battery out without opening the case anyway.


This version includes a cut out for a Magnetic clip, plenty on ebay - Name badge Magnetic clip 46 x 13.

Don't bother using the cut out -- stick the magnet to the back. There is not enough holding power for plastic + clothes. (However the cutout works ok with the magnet inside if you are attaching to a metal surface directly)

For my first version I just used a stick on badge pin (most stationery stores).

THIS HAS VERY TIGHT TOLERANCE DO NOT BRE