Thingiverse
Bafang DP-C230 Controller bracket Replacement
von Paul3171
0
Downloads
0
Likes
0
Makes
This replaces the DP C230 Controller bracket if broken.
Printed using PETG at 40 % infill, on side, with support on base plate only
Push out pin from existing bracket and reuse to attach bracket to controller.
Reuse original m3 screw
WORKS WELL
Printed using PETG at 40 % infill, on side, with support on base plate only
Push out pin from existing bracket and reuse to attach bracket to controller.
Reuse original m3 screw
WORKS WELL
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
