Thingiverse
Baffle (40mm)
por subrosalabs
3
Descargas
2
Likes
1
Makes
(Resubmitted as I posted the original baffle by mistake)
I slammed the buy button on six NF-A4x10s and was too lazy to read the specs on the baffle before printing six of these cases for a cluster. The original Baffle says it can accommodate a 30mm fan but I believe that is an error. I needed a baffle that can hold a 40x10 fan, so I made this quick and dirty remix in tinkercad. It pressure fits and does the job, though not nearly as pretty as the original design. the NF-A4x10s came with rubber feet that you can wedge between them for an ultra secure and quiet fit - I'm sure you can fit smaller fans using a similar method.
it needs supports - careful when removing them as some parts are quite fragile.
I slammed the buy button on six NF-A4x10s and was too lazy to read the specs on the baffle before printing six of these cases for a cluster. The original Baffle says it can accommodate a 30mm fan but I believe that is an error. I needed a baffle that can hold a 40x10 fan, so I made this quick and dirty remix in tinkercad. It pressure fits and does the job, though not nearly as pretty as the original design. the NF-A4x10s came with rubber feet that you can wedge between them for an ultra secure and quiet fit - I'm sure you can fit smaller fans using a similar method.
it needs supports - careful when removing them as some parts are quite fragile.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!