Bag Clip

I am taking a printer class and our assignment is to make a paperclip and post it on Thingiverse. This turned into more of a bag clip. After printing the initial test piece, I went back and widened the gap and strengthened the flex arch. The picture is of the test piece.

I would recommend printing at least 50% fill to assure it is strong enough to never break. I would also recommend ABS since it is more flexible.

It is roughly 3.5 inches long x 2 inches wide.

If scaling down, be aware that gap will be smaller and could stick together.

Update:
I put a Rev C out. Strengthening the flex arch made it more brittle and less flexible (Rev A). As a result, I went back and made multiple flex arches to allow flexibility and still add strength. I also lengthened the nose clamp to make it where it opens with less pressure. You could lose a finger the way it was.

Update:
Made a Rev D that keeps the strengthening but makes all flex arches come to a common point so all will be fle