Bag clip

bag closure remix of https://www.thingiverse.com/thing:2241289

printed with Ultimaker Cura 4.5 AND firmware Marlin 2.0.5 is good

I would say that a layer fan is essential
0.4mm nozzle
line width 0.4
layer height 0.2 ~ 2.8 mm
wall thickness 1.2mm
addresses of lines [45, 135, 0, 90]
top thickness 1.2mm
lower thickness 1mm ~
DO NOT PRINT THIN WALLS !!!!!!!!!!!!!!!
the correct temperatura and flow for each material
GENERAL print speed 65mm/s as mínimum
print acceleration 350
acceleration on exterior walls 150
impulse 1mm/s
special modes (a whole world)
enable jumper settings (ask old man for advice)