Slicer Discord
Baking tray holder – Modelo 3D imprimible de MakerWorld MakerWorld
Other House Models

Baking tray holder

19 Descargas
11 Likes
13 Makes
Ver Modelo
We have a small kitchen and always struggle where to put the unused baking trays when we need the oven and cannot store them inside. This is my solution - you can put up to 3 baking trays in and store them vertically at the side of a closet as I did. You can also use the holders to hang the trays horizontally, e.g. under a closet. The back holders have stoppers so that you cannot slide the tray out to the back by accident. As I didn't want visible screws, I fixed the holders from inside the closet. For this, every holder has 6 holes into which you can melt in a M3 thread insert. I used 4 per holder, but had to use different arrangements on each holder because of the design of my closet. For the back holders, I had to use the left and middle holes because the back wall of the closet was in the way. For the front, I had to use the 4 outer holes because of the hinges of the doors. So, just choose the positions that fit your closet. 4 screws per holder should be more than enough. I include
Categoría
Other House Models
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

HamOp también publica en

1 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección