Slicer Discord
Balancing Fisherman  – 3D-Druckmodell von MakerWorld MakerWorld
Physics & Astronomy

Balancing Fisherman

12.4k Downloads
5.3k Likes
9.4k Makes
Zum Modell
GLUE POLE IN THE PLACE SHOWN IN IMAGE BELOW GLUE POLE IN THE PLACE SHOWN IN IMAGE BELOW GLUE POLE IN THE PLACE SHOWN IN IMAGE BELOW Commercial license for all my models -→ https://www.patreon.com/MeasureOnce FISHERMAN LEANING TOO MUCH OR OFF BALANCE? If you notice that the fisherman is leaning too much then that means the pole isnt placed correctly. Add glue to the area shown below (2nd image) to adhere the pole to the fisherman. Make sure the pole is backed against the flat. Angle of the rod relative to the fisherman should be around 25 degrees. The angle of the pole will determine how straight the fisherman stands. High angles will throw off the center of mass. Check out my other balancing model! The Balancing Rock Climber https://makerworld.com/en/models/1378250-balancing-rock-climber#profileId-1426145
Kategorie
Physics & Astronomy
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

MeasureOnce veröffentlicht auch auf

44 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen