Thingiverse
Engineering
Voir le modèle
ball and beam system
4
Téléchargements
3
Likes
0
Makes
This is a beam and ball system in order to control the position of a 2.5cm ball. It requiers an specific dc motor(picture attached) and a 15mm out diameter bearing and a shaft depending on the inner diameter And a Sharp distance sensor in order to measure the distance of the ball. Each part must be printed separately.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
