Thingiverse
Ball-Bearings
von Darman_Skirata
66
Downloads
41
Likes
0
Makes
Designed a Ball-Bearing utilizing 6mm/4,5mm Airsoft BBs. It is easy to assemble thanks to the recess on the side. It's small enough so that no BBs fall out.
It should work right after printing.
If the Bearing doesn't spin smoothly try sanding the inner surface, especially at the Z Seam.
Preferably use high quality seamless BBs. Steel BBs should increase the longevity of the Bearing.
It should work right after printing.
If the Bearing doesn't spin smoothly try sanding the inner surface, especially at the Z Seam.
Preferably use high quality seamless BBs. Steel BBs should increase the longevity of the Bearing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
