Thingiverse
Ball Detent Paintball
par Private_Pleb
58
Téléchargements
51
Likes
0
Makes
This is a template I made for creating a ball detent for my BT-4.
The print takes about 12 minutes to print on my ender 3. After printing the template I filled it with hot glue to create the ball detent.
Be careful not to hold the glue gun too close as to not warm the template. Let dry for a few minutes before taking apart.
To take the template apart use an Exacto knife to first shave off any excess glue from the front to create a flat surface, then, disassemble the PLA template by cutting it apart.
Unfortunately, this is a one use template, but it doesn't use much material.
The print takes about 12 minutes to print on my ender 3. After printing the template I filled it with hot glue to create the ball detent.
Be careful not to hold the glue gun too close as to not warm the template. Let dry for a few minutes before taking apart.
To take the template apart use an Exacto knife to first shave off any excess glue from the front to create a flat surface, then, disassemble the PLA template by cutting it apart.
Unfortunately, this is a one use template, but it doesn't use much material.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
