Thingiverse
Ball joint
von ahmadmuazam1
2
Downloads
2
Likes
0
Makes
Settings for 3D printing to be setted on Slicer
I'm Using Ultimaker Cura Slicer
Print Quality: Super Quality(layer Height 0.12mm)
Infill: 100%
Infill Pattren: Triangles
Z-Seam alignment: Random
Supports: Buildplate
Enable Support Roof
Support Z Distance: 0.2
Build Plate Adhession: Raft or Brim
Once the print is complete, remove the supports and hold the part securely with pliers. Insert a screwdriver (or similar tool) into the hole in the ball, and gently rotate it in different directions. After some movement, the ball should break free from the surrounding wall and begin to move freely within the cavity.
I'm Using Ultimaker Cura Slicer
Print Quality: Super Quality(layer Height 0.12mm)
Infill: 100%
Infill Pattren: Triangles
Z-Seam alignment: Random
Supports: Buildplate
Enable Support Roof
Support Z Distance: 0.2
Build Plate Adhession: Raft or Brim
Once the print is complete, remove the supports and hold the part securely with pliers. Insert a screwdriver (or similar tool) into the hole in the ball, and gently rotate it in different directions. After some movement, the ball should break free from the surrounding wall and begin to move freely within the cavity.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
