Thingiverse
Ballet Dancer (minimal support)
von TheNit
136
Downloads
173
Likes
4
Makes
I went in the same direction as the remix by Primer (thing 2765525) to join this model together in pieces, however with pegs and sockets. This model is 25cm tall, assembled.
I have repaired the mesh as well as sculpted behind the ears and raised hand to reduce overhangs. I added a sacrificial bridge between the back of the neck and the hair bun that you can cut out later with a box cutter.
I DID NOT INCLUDE ANY CLEARANCE FOR PART FITTING. Printers are so varied in their level of maintenance, material choice, firmware and print settings from one to the next. It would be difficult for me to choose something for everyone's situation. My suggestion is to print the legs and the base first. However, when slicing the base, use an XY compensation setting - I prefer Cura's horizontal hole expansion which looks for enclosed circular shapes in each layer, then applies an XY offset to them, effectively creating space for pegs to fit better into holes. Please reference the picture I in
I have repaired the mesh as well as sculpted behind the ears and raised hand to reduce overhangs. I added a sacrificial bridge between the back of the neck and the hair bun that you can cut out later with a box cutter.
I DID NOT INCLUDE ANY CLEARANCE FOR PART FITTING. Printers are so varied in their level of maintenance, material choice, firmware and print settings from one to the next. It would be difficult for me to choose something for everyone's situation. My suggestion is to print the legs and the base first. However, when slicing the base, use an XY compensation setting - I prefer Cura's horizontal hole expansion which looks for enclosed circular shapes in each layer, then applies an XY offset to them, effectively creating space for pegs to fit better into holes. Please reference the picture I in
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
