Thingiverse
Ballistic Ball Launcher
door AccessTime
21
Downloads
13
Likes
0
Makes
V2 Update: Added a set of files to build the device using M5 screws. Two M5-20mm machine screws are used for the strip piece, and Two M4-25mm machine screws are used for the shooter piece (these two can also be M5-20mm screws if desired, though I haven't tested that change). These are common screw sizes found in nearly any M5 screw kit, the one I used is linked below.
"ball_launcher_screw_post_test_b.stl" - Use this to test your printer, slicer, etc. without having to print out a whole shooter piece.
"ball_launcher_shooter_screws_a.stl" - Replaces ball_launcher_shooter
"ball_launcher_shooter_screws_b.stl" - If you have problems with the corners lifting, this contains a partial brim which can be removed with an exacto knife after the print is complete.
"ball_launcher_screw_spring_spacer_a.stl" - Recommended plastic spacer when used with M5 screws and the extension springs in the kit (see link below).
"ball_launcher_strip_screw_a.stl" - replaces ball_launcher_strip
"ball_launcher_screw_post_test_b.stl" - Use this to test your printer, slicer, etc. without having to print out a whole shooter piece.
"ball_launcher_shooter_screws_a.stl" - Replaces ball_launcher_shooter
"ball_launcher_shooter_screws_b.stl" - If you have problems with the corners lifting, this contains a partial brim which can be removed with an exacto knife after the print is complete.
"ball_launcher_screw_spring_spacer_a.stl" - Recommended plastic spacer when used with M5 screws and the extension springs in the kit (see link below).
"ball_launcher_strip_screw_a.stl" - replaces ball_launcher_strip
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!