Balloon Car

OverviewThis is a print-in-place balloon powered car that prints in about 60 minutes with multicolor and 40 minutes in single color. Run on smooth surfaces.No assembly requiredUse with a 5 inch balloon (small kind) Also check out the standard version > LINK Tips for Successful Race!Print at normal speedsEnsure filament is dry to maintain good wheel spin and tolerancesBalloon must stay uprightDo not overinflate balloon – 50 to 75% inflation is ideal to keep balloon upright and avoid draggingInstall balloon and then inflate by blowing through nozzleSeal nozzle with finger until ready to race!Run on a flat & smooth surface ProfilesR01 - Initial releaseR02 - Added 1mm ground clearanceR02A - Single color variant of R02