MakerWorld
Sculptures
Model downloaden
Balloon Dog Magnet
186
Downloads
97
Likes
112
Makes
A balloon dog magnet. This print requires 4 round magnets of width 6mm and height 3mm. To install the magnets, put a pauze just before the holes for the magnets are covered up when slicing. Supports needed when printing. Be careful when removing the supports from the nose, this is the most fragile part of the model. ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Seller Patreon subscription.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
