Thingiverse
Balloon insufflator / fill adaptor
par realflash
34
Téléchargements
30
Likes
0
Makes
v3 with bigger inlet for faster filling.
Designed to help inflate weather balloons.
This fill adaptor accepts a 20mm ID pipe on one end with a jubilee clip to secure. The balloon neck is pulled over the large end (OD 40mm), and a cable tie is tied around the notch to stop gas leaking while it is being inflated. The legs are for tying on weights.
OpenSCAD file is attached so you can modify the dimensions if you wish.
Based on http://ukhas.org.uk/guides:fill_tube?s[]=fill
Designed to help inflate weather balloons.
This fill adaptor accepts a 20mm ID pipe on one end with a jubilee clip to secure. The balloon neck is pulled over the large end (OD 40mm), and a cable tie is tied around the notch to stop gas leaking while it is being inflated. The legs are for tying on weights.
OpenSCAD file is attached so you can modify the dimensions if you wish.
Based on http://ukhas.org.uk/guides:fill_tube?s[]=fill
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !