Balloons

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 4.6mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 5 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Blue Gray At layer #9 (0.8mm) swap to Beige At layer #15 (1.28mm) swap to Silver At layer #20 (1.68mm) swap to Jade White At layer #34 (2.8mm) swap to Beige At layer #43 (3.52mm) swap to Jade White for the rest.