Bambu A1 Corner Cable Protector (stuck cable fix)

Since relocating the AMS-lite for my Bambu Lab A1 printer away from the right side of the printer, I've encountered issues with the tool head cable getting stuck behind the top right corner of the frame. As shown in the picture below, the cable tends to stay elevated over the top bar of the frame when the tool head moves high on the Z-axis. This, combined with the tool head moving to the far right (e.g., when cutting filament), can result in the cable positioning above the corner of the frame. When the tool head then moves down, the cable can get stuck on or behind the corner, preventing the tool head from moving. In the worst-case scenario, the cable might even be ripped out of the housing by the tool head’s movement. I experimented with several cable management solutions. Some reduced the likelihood of the problem, but eventually, the cable would still get stuck. A straightforward solution was to prevent the cable from ever getting behind the problematic corner. This led to the d