Bambu A1 Quick-Swap Filament Guide

Upgrade your Bambu A1 with this custom filament guide, designed for use with a “Poor Man’s AMS” setup! By combining this guide with Arzhang Lotfi’s ingenious swap system (see link below), you can easily switch between two filaments and achieve a quick DIY multi-material experience—all with just a PTFE tube and a 3D-printed part. No special connectors required! Added a print profile for a remix if you want to use on both sides. This guide works perfectly with the modular InfinityClamp system for added versatility if you are using a filament dryer! Check out the Poor Man’s AMS here: https://makerworld.com/en/models/822710#profileId-765972 To get started, grab the InfinityClamp Base here: https://makerworld.com/en/models/1045532#profileId-1031278 And the Filament Guide Attachment here: https://makerworld.com/en/models/1045642#profileId-1031418 Assembly Instructions Remove supports. Clean off all support material from the printed parts. Connect the guide’s neck and head. They should fit sn