Bambu Forever Clip

V2 has been released, I added a little “bump” internally in the filament hole that is .003" interference fit with the filament making it hold it better with slight friction. Also added a chamfer on the lower radius to help the filament not catch while feeding. Everything else is the same, leaving V1 up if anyone still wants to use it, it is a looser fit on the filament, but V2 is better in my opinion. I understand that Amazon has run out of stock on the M4x4 screws, please be sure you are ordering the correct size, here is an alternative link to some screws that will fit from McMaster Carr, they are a little more expensive https://www.mcmaster.com/products/screws/socket-head-screws~/18-8-stainless-steel-socket-head-screws-11/system-of-measurement~metric/thread-size~m4/length~4-mm/ **To use these with the AMS they must be installed on the right hand side of the spool only** **Be sure to use Arachne wall generator due to the thin wall between the top side and the counterbore wall** **Use