Bambu Lab AMS light stand

SummaryThis remix is a pretty big departure from the original, completely new gluing sytem and has been adjusted to suit the newer (?) AMS units with the front feet closer together than the rear. My AMS has its rear feet 342mm outside to outside while the front are 334mm outside to outside. It sits perfectly on top of this frame. I have cut small feet out of some foam and attached them to the bottom - Don't try to grab extensions from the original remix because the feet length and width also seemed to be different.BE CAREFUL when putting the parts together, the thicker section on two of the pieces are 4mm longer than the other two and together form the back. The two shorter ones are for the front side. The clips are also in two different sizes.It should all fit on one build plate if you ignore the warnings about the pieces being too close. I've printed mine out of CF PETG and glued it together (using the clips) with superglue. I print a lot of high temp stuff and my top glass c