Bambu Lab - DIY Silicone Sock

About This is a DIY (Do It Yourself) Silicone Sock for the Bambu Lab X1C, P1P and P1S printers. It offers no real benefit over the standard silicone sock other than you can make your own quickly and easily at low cost and in some fancy colors if you like. :) BOM - Bill of Materials All you need is some high temp silicone intended for making gaskets. These are usually rated at 300+ C temp, it's important it's rated at a minimum of 300 C. I've tried a couple of different silicone brands and both worked great. Although I've not tried this one personally, it's inexpensive and I believe it should do the job: RTV High Temp Silicone 343° C The good thing about silicone on tube is you don't need a syringe to apply it, although it can be a bit more difficult to apply as it's generally not as viscous and a little stickier / messy. The one's I've successfully used are these: Biltema - Högtemperatursilikon 300° C Troll Factory Typ 3 HB 450° C Both were a joy to use and neither require any silicone