Bambu Lab Top LED Strip

This is an object that holds LED strips to be installed on the top glass of aBambu Lab printer. Even if the light goes through the top glass, it addsenough light to improve significantly the visibility in the chamber. The goalof this design is to be simple and non-intrusive.You'll need four riser foot to raise the AMS unit, two pieces of LED strip ofless than 1 cm wide, electrical wire and a source of power.You may need to mirror one of the LED Canopy Holder Braces, so the wire willexit the brace on the side you want. The LED canopy will fit on the Bambu Labbed if printed diagonally.Support material touching the bed plate is required only for the pins thatgoes into the braces. An infill of 20% is recommended.This object main web page is: http://www.ctheroux.com/bambu-lab-top-led-strip/.This object was designed using Solid Edge Community Edition.You can request the source files on the page listed above.