Bambu slicer max flow test tower

Description from original author: Max flow test for bambulab slicerWARNING speeds at the top of the tower set up to 476mms (slower then bambu x1c normal travel speed) so use at your own risk but you have normally stopped the print well before this. if you change it to 0.3 layer height, it won't need to print as fast but calculations will require the slicer to check.the tower increases perimeter print speed by 14mms every 1mm of z height causing an increase of 1mm3 of flow starting from 11mm3 for the first 1mmHow to set it upsetup for x1c generic abs 0.4mm nozzle (change to match your printer and nozzle)set what filament you would like to print in and adjust max volumetric to something high like 50mm3 and turn off slow printer down for better layer cooling in the cooling tabslice and print to model and stop the print when you see it starting to undextrude or have inconsistencies in the layers.mesure from the bottom to where the last layer that looks perfect.the measurement in mm + 10 is