Bambu Spool for Polymaker Filament

This is a modification of the Bambu Spool specifically designed for the Polymaker filament. I wasn't satisfied to print a regular Bambu spool and then the Polymaker expanders, so I combined the two into one 3D model so I can print them all in one. This provides adequate pressure to the spool so that it properly spins inside the AMS. To use, print both plates. Then lay your Polymaker filament on the table and pry up the cardboard, spinning it after you release the cardboard from the center spool. Work your way all the way around and then gently rip off the outer cardboard of the spool. Clean up the excess left from the center spool. Using one of the printed spool sides, locate the small tab that fits into the slot in the spool - this must also fit into the slot in the spool, as it further ensures that the spool spins correctly in the AMS. Align the spool center and the tab then press down firmly, ensuring that it is all the way flush with the filament. Flip over the spool and perfor