Thingiverse
Ban Hammer (Multi Part)
von Fuzzy_Monkey
9
Downloads
3
Likes
1
Makes
Remix of "Ban Hammer" by Vincent1289
I split the hammer head and endcap from the handle so you can print them in different materials/colors. This is setup for a fdm printer. I did not test this on a resin printer.
Note-The bottom was really snug, but I still managed to get it on with a little elbow grease. You will also need a dab of glue on the head part of the handle.
I split the hammer head and endcap from the handle so you can print them in different materials/colors. This is setup for a fdm printer. I did not test this on a resin printer.
Note-The bottom was really snug, but I still managed to get it on with a little elbow grease. You will also need a dab of glue on the head part of the handle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
