Slicer Discord
Banana Slicer v1 – Modello 3D stampabile da MakerOnline MakerOnline
Banana Slicer v1 – Bild 1 Banana Slicer v1 – Bild 2 Banana Slicer v1 – Bild 3
Household

Banana Slicer v1

11 Download
7 Likes
0 Makes
Vai al Modello
My wife needed to slice a bunch of bananas for pudding. Normally she does it with a paring knife, and 2 out of 10 times manages to cut herself. Created this to make the job easier and faster.  The banana in the picture was a little less ripe than it should have been, still works fine by pushing down on both long edges through the banana, flip it over and run your thumb along the banana to finish the slice. Drops off nicely into a bowl or cutting board. If you try to cut a very green banana, don't be surprised if it doesn't work or breaks. The cutting edge is strong, but needs to be narrow to cleanly cut. There are a bunch (pun intended) of banana slicers but they tried to be “banana shaped” and that seemed like it was only good if the banana wasn't too long, too curved, etc., so, this one should accommodate pretty much any banana, even really long ones can be cut twice.
Categoria
Household
Fonte
MakerOnline
Pubblicato
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione