Bandit Cam - Kobra 4 Camera Relocation Kit

Two Variations available: No nozzle storage Provisions to store three nozzles Kobra X version available here. This is a camera relocation kit for the Kobra X printer. It moves the camera to a higher mounting position for a better viewing angle. It also improves camera exposure by reducing light reflections off the printer base. Because this kit replaces the front half of the housing, it mounts using the original four screws and does not rely on thin clips for attachment. Since it is a replacement part rather than an add-on, no block-off plate is needed to cover the original camera opening. In my case, the wires were long enough to reach without any modifications. For this model, I have the supports set to manual tree supports and painted only where needed. The cover and body are on different plates to improve print quality. If you are not concerned about surface finish, they can be printed on the same plate. NOTE: Requires a 2mm Allen wrench at least 110mm long. The one that came with my printer worked fine. If yours is not long enough, I have included a printable handle to extend a shorter allen wrench. It's not as easy as using a regular long allen wrench but it does work. Print files for nozzle storage containers if your nozzles did not come with them can be found here I do NOT use any sort of detection for spaghetti, etc. I have no idea how this will effect this function. See Attached Documentation for full details. Click to visit Raccoon Engineering