Thingiverse
Bandsaw laser guide
door SigurdSkalson
3
Downloads
0
Likes
0
Makes
I bought a band saw for my workshop and decided to expand its functionality with a laser guide for easier positioning of the workpiece cutting line.
My holder is not perfect, but it allows you to fine-tune the beam relative to the workpiece.
After setting up, I advise you to fix the lens and laser body with a drop of glue to avoid defocusing of the laser line.
The laser module was connected to the power lines of the on-board lighting.
It is important to make sure the voltage is correct, in my case it was 5 volts!
Parts:
M5 10mm screw x 1
M5 13mm washer x 2
SYD1230(line) 12x35mm 3-5vDC laser module x 1
Heatshrink tube x 1
My holder is not perfect, but it allows you to fine-tune the beam relative to the workpiece.
After setting up, I advise you to fix the lens and laser body with a drop of glue to avoid defocusing of the laser line.
The laser module was connected to the power lines of the on-board lighting.
It is important to make sure the voltage is correct, in my case it was 5 volts!
Parts:
M5 10mm screw x 1
M5 13mm washer x 2
SYD1230(line) 12x35mm 3-5vDC laser module x 1
Heatshrink tube x 1
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!