Banjo 5th String Capo – 3D printable model from MakerWorld MakerWorld
Music

Banjo 5th String Capo

181 Downloads
28 Likes
118 Makes
Download Model
5th String Capo for BanjoThis is similar to the pen cap method, only I was able to make it smaller and less obtrusive and adjust the height to have minimal impact on the action. This type of capo will always increase the action to some extent.There are three versionsStandard: Wedges under the string on the fret only, holds the string at 3.2mm from the fretboard.Large: More stable with more surface area and higher actions (4mm)Low Action Clip On: Wedges under the string and has a clip to hold the
Category
Music
Source
MakerWorld
Published
11.12.2024
Updated
13.03.2026
Comments
0
Makes
0

Makes

Rating

Noch keine Ratingen

Comments

No comments yet – be the first!
More Music Models All MakerWorld Models More by SqueakyRobot

Similar Models

6 Suggestions

Add to Collection