Thingiverse

Bankrupt Beams

by JBlumers

10 Downloads

3 Likes

0 Makes

This bracket is an adapter for [these cheap Amazon bike lights](https://www.amazon.com/Ascher-Rechargeable-Headlight-Resistant-Included/dp/B01EUQ7ZQG/) to affix them to the front or rear boosted trucks. This thing replaces the stock backplate on the lights and uses the same screws to attach to the light to the 3d print. The only other thing you'll need to do is to drill a hole and screw in a bolt at the spot where the small indent is on either side of the print. Leave a gap of a few millimeters under the head of the screw/bolt; this is to attach the elastic band, which should be passed through the middle gap in the trucks and around each screw. Originally I wanted to build the hook right into the 3D print, but had some strength concerns and ultimately decided it was easiest to just drill a hole.

I have the Mini X, so so far that's all I've tested them on, but I imagine they would work on all of the boards in the Boosted lineup, as well as any other skate/eskate boards that use simil

boosted boostedboard boostedboards boosted board boosted boards diy shredlight diy shredlights electric longboard eskate eskateboarding headlight Headlights motorized longboard shredlights taillight boosted boostedboard boostedboards boosted board boosted boards diy shredlight diy shredlights electric longboard eskate eskateboarding headlight Headlights motorized longboard shredlights taillight

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format