Bao Dim Sum Basket

NOT RECOMMENDED FOR ACTUAL COOKING!

This is just for fun Bao Dim Sum Basket.

It's big as modeled 180mm but can be printed as small as 60mm(the 3D print shown) and you should still be able to stack and close. Pay attention to your slicer to be sure the thin walls of the top of the basket are going to print. Updated model to make this a bit easier.

3D Print is from an earlier design, but the new design should work out fine.

Weave on lid came from Square Weave Coaster.

Bao Babies shown inside came from here:

https://www.myminifactory.com/object/3d-print-bao-baby-head-from-pixar-short-74422

https://www.myminifactory.com/object/3d-print-bao-baby-sitting-from-pixar-short-74420

https://www.myminifactory.com/object/3d-print-bao-baby-standing-from-pixar-short-74421

-- UPDATED --

If you want to print the bottom without supports you can use the BaoBasket_bottom_v5_cut.stl. It is not stackable though so it will only take the top.