Thingiverse
Baofeng UV-5R Table Stand
by tramontano
94
Downloads
87
Likes
0
Makes
Not just another Baofeng UV-5R table stand: this is just perfect to leave your radio inclined 15 degrees, making it more comfortable to look at the display.
It snaps to the battery slots (slim battery), and allows the original belt clip to sit loose in place - just slide it down.
Printed in PLA, no supports needed, 0.4 nozzle and 0.2 layer height. Infill may be kept at 20%, 2-4 wall width and 3-4 top and bottom height.
It snaps to the battery slots (slim battery), and allows the original belt clip to sit loose in place - just slide it down.
Printed in PLA, no supports needed, 0.4 nozzle and 0.2 layer height. Infill may be kept at 20%, 2-4 wall width and 3-4 top and bottom height.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
