Baofeng UV-S9 Plus TPU Case

This is a TPU case for the Baofeng UV-S9 Plus radio.

There are two files, one with the letters "UV-S9 Plus" and one with no letters written on the part..

The case will offer a bit of protection from bumps and bangs for sure, but in reality the primary goal for this case was just to cover the little charging port protrusion on the battery.

When holding the radio, my finger naturally falls in the area of the charge port protrusion and the feeling of the edge of the protrusion on my finger is for me distracting to the point of annoyance.

I'm happy to say that, for me at least, this case alleviates that issue.


I tried to make the case as simple as possible to print, however, it does require some support.

(case is best printed laying on its back)

I have printed about 10 cases in all now including the UV-5r cases and found a few settings in Cura that helped produce decent prints with TPU on my Ender 3 Pro.

I'll list these below as maybe a starting point for someone