Thingiverse
Bar holder - coat hook
von Bennom
5
Downloads
4
Likes
0
Makes
I needed an additional bar to hang some stuffs, so I made this.
Originaly designed to be attached to the IKEA Lack trough the original holes, but can be used elsewhere.
Better be in wooden PLA because the aspect after sanding is pretty nice.
the Ø was adjusted for the broomstick I had, I guess theses are pretty standard.
Originaly designed to be attached to the IKEA Lack trough the original holes, but can be used elsewhere.
Better be in wooden PLA because the aspect after sanding is pretty nice.
the Ø was adjusted for the broomstick I had, I guess theses are pretty standard.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!