Thingiverse
Barebow Inspection Ring
von J_83
21
Downloads
15
Likes
2
Makes
What the holes are for (smallest to largest)
- 9.3 mm hole - Maximum shaft diameter
- 9.4 mm hole - Maximum point diameter
- 2 cm cutout - Maximum distance from the plunger to the throat of the grip on a barebow
- 4 cm cutout - Maximum distance from the plunger to the throat of the grip on an olympic recurve bow
- 6 cm cutout - Maximum distance from the pressure point of the rest to the throat of the grip on a compound bow
- 12.2 cm hole - All barebows must fit completely through this hole.
- 9.3 mm hole - Maximum shaft diameter
- 9.4 mm hole - Maximum point diameter
- 2 cm cutout - Maximum distance from the plunger to the throat of the grip on a barebow
- 4 cm cutout - Maximum distance from the plunger to the throat of the grip on an olympic recurve bow
- 6 cm cutout - Maximum distance from the pressure point of the rest to the throat of the grip on a compound bow
- 12.2 cm hole - All barebows must fit completely through this hole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!