Baroque Pictureframe

This is a baroque style picture frame I made that has enough space in its border to hold LED's and a 4mm acrylic cover. Printing 1x guideA.stl and guideB.stl 4x corner.stl 4x holder_corner.stl 4x holder_straight.stl 8x standoff.stl (optional) Assembly The mounts are made to go on a 3 to 5mm thick sheet of MDF to give the frame rigidity, for this you will need some 12mm M4 screws and nuts. To make the mounting a bit easier I used some superglue to hold the nuts in place. If you did not change the length of the corner pieces or printed some straights as extensions you will need a 31x31cm MDF board to hold the frame. I did my assembly as follows: Incase you decided to use a sheet of acrylic with the frame glue a standoff piece to the middle of the lip on each corner frame piece while leaving a 4.5mm gap at the top so the sheet can be slid in freely, Use a straight mount and the guide A to mark drill holes on the center of each side on the MDF Use a corner mount piece and the guide B to ma