Thingiverse
Bartop Arcade with 7" Display
door lotsamillions
134
Downloads
115
Likes
2
Makes
This is a nine-piece barter arcade that I designed around a specific screen, joystick and buttons. Review the Bill of Materials (BOM) for details on some of the hardware used.
This print requires a bed of at least 300mm x 300mm. I printed on a Creality CR-10.
All of the pieces except for one can be printed without supports. The Back Door only requires supports underneath the hinge pins as they don't touch the build plate. This is a very small amount of supports. The rest of the parts were designed to be flat on at least one side and have angles that eliminate the need for supports.
The parts assemble on a tongue & groove style, but adhesive is required for final assembly. I was able to print and assemble all parts with minimal razor scraping around some of the tongue & groove areas. The tolerances of your printer will determine the level of clean-up effort needed but it shouldn't take much.
Most of the parts are printed with infill around 20-25%. I did use features
This print requires a bed of at least 300mm x 300mm. I printed on a Creality CR-10.
All of the pieces except for one can be printed without supports. The Back Door only requires supports underneath the hinge pins as they don't touch the build plate. This is a very small amount of supports. The rest of the parts were designed to be flat on at least one side and have angles that eliminate the need for supports.
The parts assemble on a tongue & groove style, but adhesive is required for final assembly. I was able to print and assemble all parts with minimal razor scraping around some of the tongue & groove areas. The tolerances of your printer will determine the level of clean-up effort needed but it shouldn't take much.
Most of the parts are printed with infill around 20-25%. I did use features
lotsamillions publiceert ook op
2 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
